PAT-T Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- What is the size of the screw for the AC input terminal block of PAT-T series?
- Can PAT-T series 8 kW type switch to the single-phase input?
- What is the size of the screw for the output terminal of PAT-T series?
- What is a maximum weight that can be placed on the top of PAT-T series?
- Does PAT-T series output a peak current that exceeds its rating?
- Can PAT-T series output 0 voltage?
- Can PAT-T series output a negative voltage?
- What is the setting resolution for the output voltage and current of PAT-T series?
- Should I connect the chassis connection wire of PAT-T series?
- What is the specification of the input current for PAT-T series?
- How much airflow does the cooling fan of PAT-T series create?
- How much heat is dissipated from PAT-T series?
- How do I select a circuit breaker for PAT-T series?
- Which firmware version of PAT-T series is available for the setting of CC prioritization?
- How much leakage current will flow through PAT-T series?
- How can I switch between the constant voltage (CV) and the constant current (CC) mode in PAT-T series?
- How do I reset PAT-T series to the factory default settings?
- How do I check the firmware version of PAT-T series?
- How do I connect two units of PAT-T series in series?
- How can I control the output on/off through the external contact on PAT-T series?
- When does the RMT LED light on PAT-T series?
- How do I set the output voltage or current in PAT-T series?
- How can I control the output current by an external voltage on PAT-T series?
- What should I do if PAT-T series doesn’t operate the constant current (CC) mode?
- How can I shut down the output under the external control on PAT-T series?





